Chemline announces a breakthrough in acrylic coating technology with the Chemthane Chemthane is a high solids, low VOC, low odor coating. It is formulated in a mix ratio with a pigmented acrylic enamel and a polyisocyanate hardener. The product can be applied with a brush or roller. Or, for the best results, it can be sprayed using a single component airless pump. Chemthane offers superior gloss retention technology that supersedes historical expectations of acrylic polyurethanes. Additional features include exceptional resistance to acids, alkalis, humidity and salts commonly found in industrial applications. Designed for new construction or maintenance use over prepared and primed substrates in industrial environments, applications include steel fabricated parts tanks, pipelines, equipment, machinery, select marine structures, hand rails and many other industrial surfaces requiring painting.
Chem-thane™ RF 700
Typical coverage per coat is from 80 sq. For a lower viscosity you may add up to 6 oz. Apply by brush, roller and squeegee. For best results installation crews must work closely together and pour out only enough catalyzed material that can be cut in, squeegeed and quickly back rolled before it starts to gel. Temperature and humidity will both increase how rapidly this material sets. When working on extremely warm or humid job sites smaller mixes thinned with the maximum amount of Viscosity Reducer are recommended. Viscosity and working time are always affected by temperatures above or below that mark. When applying product — always consider the ambient, surface, and product temperature at the time and place of installation.
Uses & Typical Coverage
A quick evaporating degreaser designed for electric motors and accessories. Chem-Thane removes grease, oil and dirt from all types of surfaces and equipment. Equipment Supplies. Custom Blending. About Us. Environmental Care. Building Maintenance. Car Care. Commercial Vehicle Care. Disinfectants and Deodorizers.
This high-performance CRU produces a high gloss finish and offers high light reflectivity, is non-chalking, and has superior UV resistance. It is an excellent high performance finish coat where color stability is important and where some odor can be tolerated. Viscosity and working time are always affected by temperatures above or below that mark. When applying product — always consider the ambient, surface, and product temperature at the time and place of installation. Light Gray C and White C require 7 day lead times, but do not require minimum order quantities. Approximately 1. Adding AO powder will leave a superfine grain texture in the finish and will reduce light reflectivity. Repeated stirring the product during application to avoid the AO settling and then careful and even application is needed to avoid roller marks when AO powder has been added. Concrete substrates should be cured for a minimum of 28 days prior to application of product [except as otherwise noted on the individual Product Data Sheet]. If the substrate is not properly prepared and the appropriate profile is not achieved, failure of the product to adhere to the substrate may occur.